Roasting some Guji today I was keen to follow a successful roast that ended at L1.6 I had made a couple of days before.
I had set 1.6 as the target but as the roast progressed I noticed 1st crack was a degree or two higher than my previous roast . (Today the air pressure is high.) I intervened to increase the level so that the roast didn't end prematurely. I then found that I'd lost the development percentage and more importantly the seconds from 1st crack being shown on the display. I was aiming for 1:45 after first crack.
So, Mr Kaffelogic, Sir, there is the use case: I didn't have time to wade through the options on 'info' and even then wasn't sure I could get the timer back; would it be within your remit to re-code the firmware to be able to keep this important view from being lost and always to hand? Say a timeout? After an adjust to level with 1st crack information previously showing the screen reverts after 3 second of no input. Would that work? Got enough room?
As an aside; pilots of aircraft denote their target height above sea level as a Flight Level. FL is a number representing hundreds of feet. So FL350 really is 35 000 feet above sea level
May I suggest we do something similar, removing the useless zeros in the Core Profile names and just use a number representing hundreds of meters; such as 0-12, 12-15, 15-20, 20-27? And if Chris is going to play with names in the firmware, to add a log number, that increases his space to play with.
And then use the '8/3 3' format, suggested much earlier, for large file names plus log number.
Firmware request.
Re: Firmware request.
I think pressing profile selection button brig back that "development progress" screen.
Chris or Wayne nay be able to confirm.
Chris or Wayne nay be able to confirm.
Ben
Re: Firmware request.
Good day Angela and Ben
Thank you so much for the post Angela .
The quick and easy way to get back to the profile and development % is by pressing the PROFILE button anytime during the roast .
Thank you Ben , you are correct .
On the changes Angela . It’s a tricky situation . On the one hand you want to make roasting on the KL as easy and as clear as possible - especially for a beginner . On the other , you have so much information available to you but limited space .
Wayne
Thank you so much for the post Angela .
The quick and easy way to get back to the profile and development % is by pressing the PROFILE button anytime during the roast .
Thank you Ben , you are correct .
On the changes Angela . It’s a tricky situation . On the one hand you want to make roasting on the KL as easy and as clear as possible - especially for a beginner . On the other , you have so much information available to you but limited space .
Wayne
- kaffelogic
- Site Admin
- Posts: 514
- Joined: Thu 18 Oct, 2018 9:38 am
- x 74
- Contact:
Re: Firmware request.
My thinking is to add a 'this roast info' feature that appears instead of the 'last roast info' during a roast. It's a few extra button presses away from what you are thinking of, but also allows to show the log number, expected temperature and time the roast will auto end, as well as expected DTR.
Re: Firmware request.
Well silly me, thank you both. I never read that in my handbook.
I didn't understand the responses to the 8/3 3 problem.
Re: Firmware request.
I like the idea.kaffelogic wrote: ↑Thu 08 Oct, 2020 8:51 am My thinking is to add a 'this roast info' feature that appears instead of the 'last roast info' during a roast. It's a few extra button presses away from what you are thinking of, but also allows to show the log number, expected temperature and time the roast will auto end, as well as expected DTR.
I did asked same in way back...
Ben