You could try this profile I came up with a couple of days ago. It's meant for 60 grams and it's been working quite well. It's a "mini version" of the D-Raost profile.
Mini D-Raost.kpro
minidraost.png
Let us know how it goes!
Hi @benjaminfleon,
Thank you for the min profile. I've roasted few batches and got mixed results.
India Monsoon, 60gr (very light beans; roasted beans look pale):
India Monsoon, 60gr.png (113.17 KiB) Viewed 9090 times
Nicaragua AA, 60gr (very large & heavy beans; centre of the beans barely moves during the roast; roasted beans vary in colour):
Nicaragua AA, 60gr.png (111.8 KiB) Viewed 9090 times
TheBean wrote: ↑Thu 09 Sep, 2021 7:08 pm
Nicaragua AA, 60gr (very large & heavy beans; centre of the beans barely moves during the roast; roasted beans vary in colour):
Nicaragua AA, 60gr.png
The fan speed set to 0.91
Hi
I haven’t back read recent previous comments relating to large beans, but with the heavier beans, have you tried a higher fan speed calibration factor. I assume you know what to do to increase the global fan speed calibration factor. Without going through a proper calibration I just wing it initially. For instance I put the weighed amount of beans in roaster, enter fan calibration, then increase speed till I get adequate circulation as per the normal beans you roast. Save it. Then run the roast. Of course remember to change back afterwards.
When you get something a bit more even, then you could mess around with the fan profile. In fact as a first port of call, I’d use the “Transform Profile” on the tools menu, and in the RPM field, input something like 1.1 or less. That will shift the entire fan profile upwards (if using an existing profile). As long as the highest fan speed isn’t over 17000 rpm. If I was tweaking I’d not go over 16500 approx, so I’m not running at maximum load so to speak. (Wear and tear).
So, I’ve tried almost every single KL & forum popular profiles, tried to adjust fan speed but it looks like KL can’t handle these large beans: they won’t move at all for the first 3 minutes then barely move. I’ve reduced batch size down to 50gr but still no good results. Over 2kg of roasting, a lot of bad coffee… Any suggestions?
Hi The Bean!
I have some bigger beans like Magaroype that I haven't tried yet. Big Monsooned Malabar I think will work with ordinary profiles as the beans are very light. D-Roast and D-Light will probably work but they are not optimal if you don't have 240V. The initial fan speed of these profiles are 1570 rpm. It is possible to increase the fan speed to this value in the beginning and even higher as the power requirement isn't very high in the beginning. I have adapted the fan speed of D-Light especially at the end of the roast but also in the beginning where I lowered it to 1540 rpm as in many other profiles. This could be higher for bigger beans.
Hi @nrdlnd D-roast didn't work for me because of 240v requirement and I couldn't reduce fan speed to compensate on it. The beans I had were between 1.5g and 2g each - large and heavy, so reduced weight and increased fan speed worked quite well.
