Kaffelogic community

Hi,

I sometimes find my KL a bit clumsy to handle.
Therefore I remixed a small handle in the right dimensions. No miracles, just resized an existing project on thingiverse and any of you could do it in a heartbeat.
I printed in PETG - Not that the device gets really hot, but it is a bit more stable then normal PLA.

Printed with 50% infill
On the side
No supports

You will need 2 x M4 x 10mm screws to replace the orginal ones.

https://www.thingiverse.com/thing:5269715

Looking great! Are you going to sell printed item for who has no 3D printer?

Hey Ben.

Just download the stl file and go to a 3D printshop in your local area.
This should be a pretty cheap print.

Cool! Thanks for suggestion.

Thanks Nicolai,
Mines a little less subtle than yours

Hi

Here is a link to an old post for an off the shelf handle for those without a 3D printer.

https://kaffelogic.com/community/viewtopic.php?t=185

Cheers
G

Dis handle is awesome! Makes dumping beans infinitely easier.