Default settings log display?
Posted: Thu 14 Apr, 2022 10:56 am
I think it's important how you visualize your log. You want to get as much information as possible to be a help for eventual modifications of a profile. In "General options" you can set the ROR resolution on the Y-axis. Default is X1. With this setting the ROR often looks very "good" with not many variations up and down. You can also "smooth" the readings over time. KL with it's small and fast temperature probe reads the temperature every second. Default smoothing is 1 (one) second. There are different ways to get more information from the log. The easiest is to enlarge the Y-axis. X2 gives more information than X1 for example. With 1 sec smoothing if you set much above X2 it's difficult to see changes over time. I have tried different settings. With higher X you will need more smoothing. For some time I've used X5 and 30 sec smoothing as recommended in the manual. I think that X2 and 1 sec smoothing also is a good setting. The default X1 gives too little information but it may make you happy! I have some examples here: https://kaffelogic.com/community/viewto ... t=40#p2427
I'm not so fond of the default setting as I think it doesn't show what's really happening.
In the manual:
"3. When analysing rate of rise curves, it helps to adjust
the options settings (Use the Kaffelogic Studio menu
to select Options > Edit options). ROR y-axis multiplier
should be set to 5 so that you can see detail. ROR
smoothing of logs should be set to 30 secs so that
you can see trends more easily."
Why isn't this the default setting? How do you do?
I'm not so fond of the default setting as I think it doesn't show what's really happening.
In the manual:
"3. When analysing rate of rise curves, it helps to adjust
the options settings (Use the Kaffelogic Studio menu
to select Options > Edit options). ROR y-axis multiplier
should be set to 5 so that you can see detail. ROR
smoothing of logs should be set to 30 secs so that
you can see trends more easily."
Why isn't this the default setting? How do you do?