Software: If I wish to apply a time multiplier to a profile it all works swimmingly well! However if I have zone times set they do not get the operation acting on them. Chris could you add this to some future release?
Firmware: Switch debounce? I assume there is some sort of signal debounce applied in circuitry but could the repeat time delay be increased? I have started to get three presses when only one was intended. Info followed by start gave me "press > to end"!
Ever grateful.
Software and firmware requests
-
kaffelogic
- Site Admin
- Posts: 557
- Joined: Thu 18 Oct, 2018 9:38 am
- x 83
- Contact:
Re: Software and firmware requests
Even better, your suggestions can get added to the current release. Both are good calls, thanks.
Studio 3.1.4 beta has been released including the ability to apply the transformation to the zones and corners. The transform feature only transforms the tab you are on, so you have to visit three tabs (Roast profile curve, Fan profile curve, and Profile settings) and transform each one for a complete transformation of everything. This process is made easier by the way the transform dialog now remembers the most recently used transformation parameters. (I considered having the ability to transform all three tabs simultaneously, but the challenge is in the undo/redo feature which works on a per-tab basis and so this could create a non-intuitive undo state.)
I looked into the debouce code and it was set with quite a short debounce period (1 ms on, 20 ms off). I have pushed this up to 20 ms on, 30 ms off. Let me know how it goes. This is in firmware 7.3.9 beta. Also included in that update is a USB memory stick icon that appears when a log is being recorded - let me know if you like it or not, I'm not sure if its useful or visual clutter.
Studio 3.1.4 beta has been released including the ability to apply the transformation to the zones and corners. The transform feature only transforms the tab you are on, so you have to visit three tabs (Roast profile curve, Fan profile curve, and Profile settings) and transform each one for a complete transformation of everything. This process is made easier by the way the transform dialog now remembers the most recently used transformation parameters. (I considered having the ability to transform all three tabs simultaneously, but the challenge is in the undo/redo feature which works on a per-tab basis and so this could create a non-intuitive undo state.)
I looked into the debouce code and it was set with quite a short debounce period (1 ms on, 20 ms off). I have pushed this up to 20 ms on, 30 ms off. Let me know how it goes. This is in firmware 7.3.9 beta. Also included in that update is a USB memory stick icon that appears when a log is being recorded - let me know if you like it or not, I'm not sure if its useful or visual clutter.