Kaffelogic community

Hi Sean, I may be directing the question to the wrong person, but you seem to know a bit about the Link and I have taken the dangerous risk of assuming you might have worked with either Kaffelogic or Nucleus at some point. I'll jump into the conversation with my question anyway haha. I've also been ...

Hey Geronimo, I did as you suggested and lowered the starting temp. Sure enough, the low voltage warning went away. It's so weird though, because the profile of that roast started way above the new set temperature lol. It's getting late now, but I'll continue tinkering and let you know what I come u...

Also, of note - the adjustment that came up was to slightly increase the starting temp at the beginning of the graph. This flattened the profile curve a bit, hence needing only 960 watts instead of 1180 watts. I’m confused why that would suddenly trigger the low voltage warning

Hey there, I have been trying to create my own profile and run into low voltage problems. When I load the new profile into my roaster it says that 235volts is not enough. The strange part of it is that I had a roast profile that required much higher watts and it ran fine, then when I adjusted it to ...

I have been having a play around with making new profiles but I have been having a problem with the beans heating too fast warning at the start of some of the roasts. It seems that I will put some beans in (100g) and start it, and then I'll get that warning after about 15seconds into the roast. Then...

Hi Steve, I have just tried to use your LightSide profile and I have the low power issue. It says it requires 240volts and apparently I only have 236 volts available to draw from. I have checked the log and it doesn't quite max the power available, but it's just annoying always having the low power ...